Tariff Concession Orders

FABRIC, WOOL PILE, PAINT ROLLER, woven textile backing, having
 ALL of the following:
   (a) a man-made fibre content NOT exceeding 25%;
   (b) pile height between 8 mm and 38 mm (both inclusive);
   (c) a thermal bonding acrylic latex backing

MOHAIR PILE FABRIC on a woven textile backing

FABRIC, PILE, PAINT ROLLER, woven textile backing, with OR
  without a fusible filament within the weave, having ALL of the
  following:
    (a) a combination of ANY of the following fibres:
          (i) polyester;
         (ii) acrylic;
        (iii) modacrylic;
         (iv) polyethylene;
          (v) nylon;
    (b) pile height between 3 mm and 30 mm (both inclusive);
    (c) thermal bonding backing of acrylic latex coating

TAPES, FASTENING SYSTEM, hook or loop, having a cut or uncut pile,
 whether or not coated with adhesive

RIBBONS, velvet, having woven edges on both sides, width NOT
 exceeding 55 mm

WEBBING, ELASTOMERIC, with a composition of rubber and
 polypropylene, having ALL of the following:
   (a) warp and weft construction;
   (b) rubber content minimum 25% but NOT exceeding 55%;
   (c) polypropylene content minimum 45% but NOT exceeding 75%;
   (d) minimum elongation of 50%;
   (e) minimum width of 45 mm

WEBBING, elastomeric, rubber and polypropylene composition,
 having ALL of the following:
 (a) warp and weft construction;
 (b) rubber content of at least 25%, but NOT exceeding 45%;
 (c) polypropylene content of at least 55%, but NOT exceeding 75%

FABRIC, woven, cotton body huckaback weave, polyester cotton
 selvedges, width NOT exceeding 28 cm

BANDAGES, CREPE, stretchable, having BOTH of the following:
  (a) width NOT greater than 20 cm;
  (c) length NOT greater than 2.6 m unstretched or NOT greater 
      than 5 m stretched

RIBBON, woven edge, width NOT greater than 3 mm

TAPE, shrinkage, selvedged edge of polyester yarn, having a
 shrinkage factor of NOT less than 7.0% at 120 degrees C, 12.5%
 at 150 degrees C and 21.0% at 200 degrees C

RIBBON, WOVEN, polyester/rayon, width NOT less than 11 mm but NOT
 exceeding 38 mm

RIBBON, SERVICE OR CIVILIAN MEDAL OR REGALIA, being EITHER of
 the following:
   (a) moire pattern;
   (b) corded

TAPE, LIFT, EXTERNAL LOUVRE BLIND

WEBBING, VENETIAN BLIND, uncoated, consisting of 2 tapes connected
 at intervals by cross bands

FABRIC, RIBBON, UN-INKED IMPRESSION, woven, having ALL of the
 following characteristics:
   (a) width 3 mm OR greater but NOT exceeding 300 mm;
   (b) grammage 40 g/sq m OR greater but NOT exceeding 75 g/sq m;
   (c) length 320 m OR greater but NOT exceeding 980 m;
   (d) edges sealed by hot knife slitting

RIBBON, ORGANDIE, 100% polyamide, having woven edge, organdie
 and single face satin alternating stripes, width NOT less than
 18 mm but NOT exceeding 50 mm

RIBBONS, 100% nylon, woven edge, single sided satin, width NOT
 greater than 25 mm

POLYESTER TAPE, unshrunk, weighing not more than 117 gsm, stamped
 with indelible ink referring to trade name and FAA approval,
 approved under USA Federal Aviation Administration Regulation
 FAR 21 (subpart k)

RIBBONS, having woven edges on both sides, 100% polyester, having a
 width of NOT less than 5 mm and NOT greater than 80 mm, being ANY
 of the following:
   (a) printed;
   (b) tartan or plaid;
   (c) velvet;
   (d) moire pattern;
   (e) double face satin

RIBBONS, having ALL of the following characteristics:
   (a) woven edge;
   (b) polyamide combined with metallised yarn;
   (c) three yarn colours;
   (d) width NOT less than 23 mm and NOT greater than 51 mm;
   (e) NOT printed

RIBBONS, woven, having woven edges BOTH incorporating a continuous
 wire strand

RIBBONS, having woven edges on both sides, 100% polyester or nylon,
 having a width of NOT less than 5 mm and NOT greater than 80 mm,
 being ANY of the following:
   (a) printed;
   (b) tartan or plaid;
   (c) moire pattern;
   (d) double side or double face satin

TEAR WEBBING, shock absorbing, polyester, woven

POLYESTER SLEEVING REELS, self-closing, black, having a diameter 
NOT less than 4 mm and NOT greater than 50 mm

STRAPPING, woven polyester, adhesive bonded, having a width NOT 
less than 9 mm and NOT greater than 19 mm

TAPE, CURTAIN HEADER

RIBBONS, woven edge, width 1.5 mm or greater but NOT exceeding 75 mm
 incorporating at least 60% by weight of metallic thread

RIBBON, silk embroidery, in widths of 2 mm to 7 mm inclusive

RIBBON, SILK, EMBROIDERY

BRAIDED TUBING of kevlar and/or carbon fibres

FRINGE, bullion, wound with gold or silver

SLEEVING, expandable, manufactured from monofilament, having a
 diameter of 40 mm or less

BRAID, footwear, NOT exceeding 2 mm in diameter, having a
 composition of ANY of the following:
   (a) linen;
   (b) polyester;
   (c) nylon

BRAID, flat, NOT exceeding 7 mm in width